REV Vents.

REV Cold Air Intake:

Does your REV need more air?  Are you tired of your sled bogging in deep powder from snow build-up on the stock intake?  Have you been looking for a way to get more air to your engine?  Here is the answer to your questions.  The REV cold air intake.  This vent attaches to the outside of the panel, below the stock intake, and allows you to open up the stock airbox.  This vent almost doubles the surface area of the stock intake.  The vent is solid perf aluminum with a mesh covering.  On this vent the OEM spec pre-filter material is wrapped on the outside of the mesh to make snow removal easier.  Don't worry about trees, twigs, branches, etc. tearing through this vent... Nothing will ever tear through, and they actually add structural strength.  Only Available in Black.



Available in BLACK only.
REV Cold Air Intake




REV Vent Kit:

Are you tired of scorching hot clutches? Are you tired of burning belts? How is all that heat going to ever get out without any venting? Do you do a lot of boondocking in the trees? Do you fear that other vents might rip if you bump a tree? These vents are the ultimate for extreme riders. They are made of 16ga perforated aluminum with a super strong coated mesh covering. The clutch side vents have an extra layer of OEM spec waterproof material between the aluminum and the mesh to keep super fine powder out but let lots of air in. Unlike all other vent kits that have mesh attached to a tiny little aluminum frame these vents are a solid perforated aluminum. Nothing will ever tear through, and they actually add structural strength. Can be ordered in any color: (Blue, Yellow, Red, White, Black). Please specify when ordering.

Cost: $170 + S&H

This kit includes:

2ea - Middle Vents - (Left & Right)

2ea - Knee Vents - (Left & Right)

Instructions, Templates, Rivets w/back-up washers.

Vents can be ordered separatly, Use drop down menu for ordering.

REV Vents
Please specify color (Blue, Yellow, Red, White, Black)